Open Wave Height Logger

OWHL Build Guide

Skip to content
  • Home
  • Electronics
    • 1. Ordering Curcuit Boards
    • 2. Circuit Board Assembly
    • 3. Programming Newly Assembled OWHL Boards
    • 4. Battery Holder Options
  • Housing
    • 1. Making the Bulkhead
    • 2. Housing Assembly
    • 3. Sensor Calibration
  • Anchoring
    • 1. Anchoring in Soft Sediments
    • 2. Anchoring in Hard Reef
    • 3. Anchor Block Build
  • Post-Processing Info
  • Additional Resources
    • Materials List
    • Wave Sensor Comparison
    • Photos
    • Contact

OWHL Housing Build

Fig. 19: Exploded view of the OWHL housing components

In This Section

  1. Making the Bulkhead
    1. Simple Build Instructions for Making the Bulkhead
    2. Tapping the Hole for the 1/8″ NPT Fitting
    3. Gluing the MS5803 Circuit Board to the Bulkhead
    4. Modifying the Cleanout Plug
    5. Making the Oil Reservoir
  2. Housing Assembly
    1. Oil Reservoir Installation
    2. Filling the Oil Reservoir
  3. Calibration
< PREV
TOP
NEXT >
Proudly powered by WordPress